911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Clutch Release Bearing: Service and Repair
Removing and installing release bearing
Preliminary work
1. Remove engine-transmission unit.
2. Remove the transmission.
3. Remove clutch.
Removing release bearing
Information
The snap ring can be fitted only using a workshop press. Use a block of hardwood as a pressure piece.
Overview
1. Position the release bearing -3- and press down on the pressure plate -6- using a suitable pressure piece (e.g. block of hardwood) until the snap
ring -1- can move freely.
2. Remove snap ring -1-.
3. Take off the release bearing -3-.
Installing release bearing
Information
^
Do not grease sliding surfaces of release bearing and guide sleeve.
^
The sliding surface of the release bearing is slotted irregularly. This is not a defect.