911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
1. Carefully raise the wiper link and position the wiper motor from below.
2. Push electrical connector onto wiper motor until it is felt to engage.
3. Secure the wiper motor with the three fastening screws -2- to the wiper link. - Tightening torque: 6 ftlb.
4. Screw down the fastening screw -3- for the wiper link. - Tightening torque: 7.5 ftlb.
5. Connect battery, ignition on, and actuate wiper motor.
6. Allow wiper motor to run in parking position. Place the link on the drive on the wiper motor. Place fastening nuts -1-. The installation position of
the link is identified by a 0 marking (parking position) on the console.
7. If the position -0- matches, then screw down the fastening nut -1-. - Tightening torque: 13 ftlb.
8. Connect the battery.
9. Switch on the wiper motor and check the wiper position.
Reworking wiper motor
Touching up wiper motor
Left plenum chamber cover