911 Turbo Cabriolet AWD (997) F6-3.8L Turbo (2011)
1. Unscrew fastening nuts -1- and fastening screws -2- .
2. Remove wheel housing liner -A- .
Remove front wheel housing liner - front section
1. Unscrew fastening screws -2, 3- and remove the front section of the front wheel housing liner -B- .
Installing front wheel housing liner
Install front wheel housing liner - front section
1. Insert front section of front wheel housing liner -B- .
2. Tighten fastening screws -2- . - Tightening torque: 2.8 Nm (2 ftlb.)
3. Tighten fastening screws -3- . - Tightening torque: 2.8 Nm (2 ftlb.)
Installing front wheel housing liner - rear section
INFORMATION:
-
Push in wheel housing liner toward the outside up to contact in wing stop position.