911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
Installing oil cooler
Note:
^
Always replace the O-rings for the oil cooler!
1. Replace seals. Replace the four O-rings -arrows between the bracket and oil cooler. Coat the O-rings with a small amount of universal grease and
insert.
2. Place oil cooler in position with the four M6 screws and tighten.
Tightening torque of M6 screws = 10 Nm (7.5 ft. lbs.)
3. Fasten coolant hose -2- on the oil cooler -1-. To do so, place the coolant hose -2- in position and tighten the screw-type hose clamp.
4. Install the crankcase ventilation tube. For this purpose, place the crankcase ventilation tube with the union nut -arrow- in position, but do not
tighten yet.
Note:
^
Always replace the flange seal for the crankcase ventilation tube!
5. Replace the flange seal; then place the two M6 screws -arrows- in position and tighten.
Tightening torque for hexagon-head bolts 10 Nm (7.5 ft. lbs.)