911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
Oil Pressure Sender: Service and Repair
Removing and installing oil pressure sender
Removal
1. Undo fastening screw M6x34 on the air cleaner housing.
2. Undo hose clamp between the air cleaner housing and intake manifold.
3. Tilt the complete air cleaner housing 90° upward and remove to the rear.
4. Pull off the connecting hoses between the charge air coolers and the pressure pipe. To do this, unclip the locking clips with a screwdriver. Then
return the locking clips to installation position. Additionally undo a fastening screw on the right-hand pressure pipe side.
5. Undo pressure pipe -middle- by removing the spring clip -5-, hose clamp -3-, hexagon-head bolts -1 & 2- and electrical plug -4-.
6. Pull off the electrical plug. Undo the fastening screws and remove the throttle body.