911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
Oil Temperature Sensor/Switch: Service and Repair
Removing and installing oil temperature sensor
Removal
1. Undo fastening screw M6x34 on the air cleaner housing (A/f 13).
2. Undo hose clamp between the air cleaner housing and intake manifold.
3. Pull off electrical wire connector of the hot film mass air flow meter:
^
To do this, push the plug downwards and press on the grooved surface at the sides.
^
Then pull the connector up and off.
^
Open the omega clip on the left side of the air cleaner housing and take out the electrical wire of the hot film mass air flow meter.
^
Re-close the omega clip for the removal (risk of breakage)
4. Tilt the complete air cleaner housing 90° upwards and remove rearwards.
5. Pull off the connecting hoses between the charge air coolers and the pressure pipe. To do this, unclip the locking clips with a screwdriver. Then
return the locking clips to installation position. Additionally undo a fastening screw on the right-hand pressure pipe side.
6. Undo pressure pipe -middle- by removing the spring clip -5-, hose clamp -3-, hexagon-head bolts -1 & 2- and electrical plug -4-. Pull off vacuum
hose to the control valve.