911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
1. Removing coding pin and pin.
a. Pull slide -B- in -direction of arrow 1-.
b. Lever out fuse -arrow 2- with a small screwdriver and remove completely.
c. Pull out coding pin -A- with pliers. Press pin out of flat connector using press-out tool.
1. Removing coding pin and pin
a. Insert coding pin -A- and pin into the flat connector until it engages.
b. Insert fuse -2- in -direction of arrow- until it engages.
c. For seat installation: Insert counter plug into vehicle and push in slide -B-.
Removing and installing pin housing for seat heating and belt buckle
-
-C- Seat heating pin housing
-
-D- Belt buckle pin housing
1. Removing pin housing for seat heating and belt buckle.
a. Cut tie wrap on rear side of central plug with side cutters.
b. Push fuse -2- away from flat connector in -direction of arrow 2-.
c. Pin housing: Push out the belt buckle -D- and seat heating -C- in -direction of arrow 1-.
1. Installing pin housing for seat heating and belt buckle
a. First insert the seat heating pin housing -C-, then the belt buckle -D- into the flat connector.
b. Push fuse -2- onto the flat connector.
c. Observe the line route and secure with tie wraps on the rear side of the flat connector.
Test plan for the seat heating