911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
7. Unlock plug of the rate-of-turn sensor with the ignition switched off -arrow on the plug- and pull it off. Undo fastening nuts -arrows- and remove
the rate-of-turn sensor with bow.
Note:
^
Pull at the plug housing only! Never pull the electrical connections!
8. Remove the airbag control module.
Note:
^
Socket wrench insert 9259 is required for removal and installation of the airbag triggering unit.
9. Undo the fastening screws -arrows- on both sides and remove the holder -2-. To do this, guide the electrical wiring and, if necessary, the keylock
cable through the holder opening.
Fitting
Caution:
^
The rate-of-turn sensor is a micro-mechanical component and is very sensitive to impacts!