911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
4. Loosen fastening nuts M10 from the spring strut mount in the vehicle interior.
5. Loosen stabilizer mount at stabilizer (counter with open-ended wrench).
6. Loosen screw connection between spring strut/wheel carrier -arrow-.
7. Pull out (remove) spring strut.
Installation
Install in reverse order.
Information:
^
Before installing, give the parts a visual check!
^
Replace fastening nuts!
^
Do not grease screwed connections in Dacromet finish - aluminum color!
^
Use correct tightening torques!
^
When new parts are installed that affect vehicle height, suspension alignment must be carried out!
^
Before tightening the fastening nuts, adjust spring strut mount in accordance with the applied marking (position of the three fastening nuts)!
-
Insert spring strut into vehicle. Tightening torque 46 Nm (34 ftlb.).