911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
3. Remove retainer plate (lid) (four screws).
4. Heat wheel bearing housing to approx. 100°C (max. 120°C). Press out wheel bearing with tubular piece VW415A (tool -C-).
Information:
^
Pull the inner bearing race several millimeters off the wheel hub so that the separator can be put into place.
^
For this purpose, use a two-claw puller in combination with a suitable pressure piece (e.g. VW 433).
5. Press inner wheel bearing race off the wheel hub. Use the press-out mandrel P297a in connection with the separator.
Installing
1. Before installation, clean the bore in the wheel bearing housing and remove any surface irregularities with a polishing cloth.
2. Heat wheel bearing housing to approx. 100°C (max. 120°C). Insert new wheel bearing, and then press again slightly using pressure piece 9247/3
-D- and tubular piece VW415A -C-.