911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
/f6-3.6l_turbo/Page-512002.png)
3. Drive in sealing ring with pressure piece 9256 as far as the mounting face.
4. Install guide tube and tighten the fastening screws.
Tightening torque: 10 Nm (7.5 ft. lbs.).
Note:
^
The guide tube fastening screws are micro-encapsulated, therefore replace screws entirely.
5. Clean teeth of the input shaft and grease with a thin coat of Olista Longtime 3 EP (only as corrosion protection).