911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
Limited functionality of the rain sensor when the following information points are not observed:
NOTE:
-
An adhesive pad must be used when reinstalling the rain sensor. See PET, main group 9, sub group 04.
-
When assemblying the adhesive pad, air should not be trapped between the windscreen and the adhesive pad or between the adhesive pad and the
rain sensor.
-
When installing the adhesive pad, a temperature of approx 20 Dgree C for the windscreen, the rain sensor and the adhesive pad must be ensured.
Carefully heat the windscreen with a hot-air gun for example.
-
The sensor on the sticking surface must not be touched by fingers.
-
If the sensor is new, remove the protection cap before the sensor is stuck onto the windscreen.
-
When sticking a new sensor, make sure that no air pockets are caught between the gel and the windscreen. Air pockets could impair the function of
the sensor.
-
Sensor, orientation lights, wires and wiring ducts are spare parts.
If the old rain sensor is installed: begin with the instructions on Page 5.