924 S L4-2479cc 2.5L (1986)
6. To tighten, turn tensioning roller counter-clockwise. To loosen, turn tensioning roller clockwise. Move tensioning roller accordingly with Special
Tool 9244 (adjusting wrench).
7. Tighten mounting nut to torque of 45 Nm (33 ft lbs), making sure to counterhold.
8. Crank engine two turns clockwise and align TDC mark on camshaft sprocket with mark cast in console for distributor cap. Crank engine
counter-clockwise from this position about 10 crankshaft degrees.
9. Recheck, and if necessary correct tightness of toothed drive belt.