924 S L4-2479cc 2.5L (1986)
20. Disconnect starter wire harness on clutch housing. Pull out release lever shaft mounting bolt with a 8 mm bolt. Unscrew the four central
tube/clutch housing mounting bolts.
21. Pull back selector rod again, which had been pushed forward for removal of the transmission, so that nothing will be damaged when moving the
central tube.
22. Move back central tube far enough until central tube housing rests on transmission carrier. If central tube cannot be moved out of clutch housing
without applying force, hold engine tight with transport eye mounted on camshaft housing with Special Tool VW 10-222.
In this case the engine has excessive inclination at rear - check engine suspension.
NOTE: Make sure brake lines are not damaged by the central tube.