944 S L4-2479cc 2.5L DOHC (1987)
Figure 4
2.
Spray or brush a coat of hardener on the valve guide contact surface of the seal (see Figure 4). Use protective gloves. Drying time of the hardener
is approximately 5 minutes. Seals coated with hardener must be installed within ten minutes.
3.
Push a protection sleeve, Part Number 000 043 084 00, on the valve stem. Oil the valve stem seal sealing lip lightly and push the seal onto the
protection sleeve.
Figure 5
4.
Apply a coat of cement on the seal contact surface of the valve guide using a small brush. Immediately press the valve stem seal carefully on the
valve guide with tool 10-204 (Figure 5).
5.
Do not start engine for at least 12 hours after valve stem seal installation.
Caution:
Part numbers given in this bulletin are for reference only. Always check with your Parts Department for the latest parts information.
Repair Procedure:
944S (4 valve engines)
Refer to the workshop manual Volume 1-A, pages 15-118 through 15-122 for valve stem seal replacement.