944 S L4-2479cc 2.5L DOHC (1987)
16 Valve Engine
5a. Turn crankshaft clockwise until TDC mark on camshaft sprocket is aligned with cast mark in mount for distributor cap.
5b. TDC marks on flywheel and cast clutch housing must also be aligned.
Balance Shaft Timing Marks
6. Check basic position of balance shaft sprockets. Marks on sprockets should be aligned with marks of rear drive belt cover.
7. Prepare special tool P 9201 for testing. Pull out lockpin on special tool and push gauge pin opposite the lockpin out as far as it will go. Zero
telltale needle.