944 S L4-2479cc 2.5L DOHC (1987)
Parts Information:
The earlier version parts are no longer available. The new pipe with the new hardware must be used.
Parts Information (Cont.):
No.
Description
New
1
CO sample pipe 944/924S
944 111 175 05
(1)
CO sample pipe 944 Turbo
951 111 175 02
(1)
CO sample pipe 944S
944 111 275 02
2
Clamp (Qty. 2)
N 020 609 3
3
Bolt (Qty. 3)
N 010 215 13
4
Bracket
944 111 177 02
5
Bracket
-
-
Engine lift bracket
944 101 413 02
(except 944S)
-
Cam end cover gasket
928 105 189 02
(except 944S)
Work Procedure:
1.
Remove CO sample pipe and bracket at clutch housing.
On 2 valve engines, remove the engine lifting bracket on the back of the cylinder head.
Note:
Because the engine lifting bracket bolts also secure the cam end cover, the cover gasket must be replaced.
2.
Install the new clutch housing bracket and torque to 75 N-m (55 ft.lb.). Install the lift bracket (2 valve) and torque to 8 N-m (5.8 ft.lb.).
3.
Install the new pipe by first starting the union nut on the exhaust pipe. Next install and tighten both pipe clamps. Position clamp bolts rearward of
CO sample pipe (See Figure 3).
4.
Tighten the union nut to 30 N-m (22 ft.lb.). The old pipe cap and clamp can be installed on the new pipe.
Labor Operations:
26041900 120 TU - 924S, 944
26041900
130 TU - 944 T, includes replacing cam end cover gasket
26041900
90 TU - 944S
Caution:
Part numbers given in this bulletin are for reference only. Always check with your Parts Department for the latest parts information.