944 S L4-2479cc 2.5L DOHC (1987)
Note: Installation marks (not TDC mark) on flywheel and damper must be aligned. Before installing the central tube, turn flywheel and damper
until installation marks face down at an angle (toward starter opening).
1. Wrap pieces of adhesive tape around insulation sheet and coat mating surfaces for body with an assembly paste (e.g. rubber lubricant) to facilitate
installation.
A = Adhesive tape
2. Install speed and reference mark transmitters.
Note: Transmitters have permanent magnets. Make sure metal particles are not stuck on the transmitters before installing.Note marks of