944 S L4-2479cc 2.5L DOHC (1987)
22. Insert circlip for synchronizer.
23. Insert 5th gear synchromesh ring.
24. Heat clutch to about 120°C (250°F) and mount, driving it on against stop with a suitable piece of pipe if necessary.
25. Heat 2nd ball bearing inner race to about 120°C (250°F) and install.
26. Install dowel sleeves, position gasket and mount rear cover.
27. Heat 1st ball bearing inner race to about 120°C (250°F) and install.
28. Tighten bolt for input shaft to specified torque.
29. Tighten cover/gear carrier bolts to specified torque.
30. Press in new end cover.