944 S L4-2479cc 2.5L DOHC (1987)
14. Determine thickness of shim for 5th gear.
Specifications
Measure distance "a" with a depth gauge and refer to following table for thickness and part number of shim.
15. Heat 5th gear/drive pinion to about 120 °C and install gear with collar facing drive pinion. If necessary, knock on against stop with a suitable
mandrel.
16. Tighten bolt for drive pinion to specified torque.
17. Clamp input shaft in a vise that shafts are vertical.
18. Lubricate cylindrical rollers of input shaft bearing with a little grease and press outward.