944 S2 Cabriolet L4-2990cc 3.0L DOHC (1991)
1. Set up and align trailing arm under a press on VW 459 and suitable bases for installation of the wheel bearing. Remove trailing arm again and heat
to 120-150°C. Insert angular ball bearing and press in slightly on the aligned bases.
2. If applicable, press in new inside and outside rubber mounts against stop.
3. Press in wheel hub after installation of the circlip.
4. Install trailing arm. Tighten bolts and nuts to correct tightening torque. Mount spreader arm and parking brake shoes (see Parking Brake).
Note: Insert drive shaft before mounting the vibration damper on the trailing arm on the left side.
5. Adjust parking brake. Bleed brakes. Check wheel alignment.