Boxster (986) F6-2.5L (1998)
NOTE: Do not trap wiring harness.
2. Tighten fastening screws (Torx T 45) -arrow- to 23 Nm (17 ftlb.).
3. Connect the 2 push rods. For this purpose, fit the retainer or fastening nut (standard fastening nut as of April 2001) -arrow-.
NOTE:
-
Adjusting the brake pushrod length changes the position of the brake pedal.
-
Perform a fine adjustment of the brake pushrod if the correct position of the brake pedal is not given.
-
After the brake pushrod is adjusted, check the brake light switch adjustment.
4. Check the position of the brake pedal -Dimension X = 45 + 5 mm-. Perform measurement between the centre of the brake pedal plate and the
accelerator pedal. Perform a fine adjustment of the brake pushrod if the correct position of the brake pedal is not given.