Boxster S (986) F6-3.2L (2001)
/f6-3.2l/Page-1434015.png)
16. Fastening convertible-top covering end piece on the tension bow (convertible top closed)
-
Apply adhesive over approx. 300 mm on the left and right sides of the convertible-top covering end piece and fold it over.
17. Fitting retaining clips, pull strip and centre cover moulding in the roof frame
Model version with roof liner
a. When pressing the centre cover moulding into the roof frame, make sure that the top side of the convertible top is free from wrinkles.
b. If necessary, shift the pull strip to the left or right.
Model version without roof liner
The centre cover moulding is additionally secured using a retaining clip (small inset).
Press the retaining clip into the groove of the centre cover moulding and pull downwards over the roof frame edge.
18. Fitting tension bow seal
-
Press the tension bow seal into the outer groove of the tension bow.
