Boxster S (986) F6-3.2L (2001)
4.1. Position the convertible-top support -6- on the roll-over bar and fasten it with the fastening screws -7-. Make sure that when tightening, the
convertible-top support is pressed in the direction of arrows -A and B-.
5. Install seat belt.
5.1.Position the belt reel at the bottom -8- and the deflector at the top -9- on the roll-over bar -1- and fasten with the fastening screws -10, 11-.
6. Fitting stop buffer on the roll-over bar
6.1. Position bracket (stop) -12- on the roll-over bar -1- and tighten with the fastening screws -13-.
INFORMATION:
- When inserting the push bar -Arrow- of the roof frame into the roof frame, make sure that it is routed through the rubber strap of the
B-pillar.
- Use assembly grease when fitting the pins.
7. Joining drive lever to the B-pillar and push bar
7.1. Press in Teflon bushings -14- in the bore of the drive lever on both sides.
7.2. Position the drive lever -16- on the B-pillar -15- and join it with the pin, -18- 8 x 45.
7.3. Position the push bar -17- on the drive lever -16- and join it with the pin, -18- 8 x 45.
7.4. Press the retaining clips -19- into the pins -18-.
INFORMATION: Use assembly grease when fitting the pins.
8. Joining convertible-top support to the B-pillar
8.1. Press in Teflon bushings -14- in the bore of the drive lever on both sides.
8.2. Position the B-pillar -15- on the convertible-top support -5- and join it with the pin -18- 8 x 45.
8.3. Press the retaining clips -19- into the pins -18-.
INFORMATION Use assembly grease when fitting the pins.
9. Installing main bow