porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Vacuum Pump, Brakes|Description and Operation|Page 3360 > < Vacuum Pump, Brakes|Description and Operation|Page 3358
Page 2
background image

phase.

Function: By bypassing the throttle -D- (bypass around the throttle from connection -B- to connection -C-), the rate of flow and so the vacuum are
increased locally by the sucking jet pump -1-. This greater vacuum is applied to the brake booster connection -A-.

Preliminary Work

1. Cover the vehicle with protective covers in the rear area in such a way that the body can not be damaged.
2. Move convertible top to service position. To do this:

-

Open the convertible top until the convertible-top compartment lid is half open.

-

Detach cloth covering. Disengage the rear strip on the left and right sides of the cloth covering in downward direction.

-

Detach tension cables. Press the ball socket of the tension cable out of the ball head of the adjusting piece on the left and right.

-

Move convertible top to service position. To do so, press the tension bow of the convertible top towards the main bow, until it reaches its
locking point (press the convertible top forwards until it engages).

Removing Sucking Jet Pump

NOTE:  In order to guarantee the accessibility of the sucking jet pump, especially for installation purposes, the intake pipe centre piece and the throttle
body (together) must be removed!

1. Remove ignition key.

CAUTION:
Danger of damage!
Pay attention to the position of electrical leads and hoses in the area of the sucking jet pump and the hoses (left/right and above/below)!
Lay the hoses and leads in the same position as before removal!

2. Disengage the cable -2- and then unlock and disconnect the hose -3- on both sides. Remove the intake pipe centre piece and the throttle body -4-.

To do so, undo the hose clamps -arrows- and the fastening nut -5-.

3. Disconnect the leads (3 connections) -A, B, C- from the sucking jet pump -1-. To do this:

-

Undo the screw (M6) from the clamp and remove the clamp -arrow-.

-

Pull off lead -B-.

-

Remove leads -A and C-. To do so, remove the circlip and then unlock the connection and pull off the lead at the same time.

Vacuum Pump, Brakes|Description and Operation|Page 3360 > < Vacuum Pump, Brakes|Description and Operation|Page 3358