Boxster S (986) F6-3.2L (2001)
/f6-3.2l/Page-318011.png)
Installation position of oil extraction pump at cylinder head 1 - 3 (flywheel side): The arrow for the direction of rotation or the marking "1 - 3"
must face the crankcase. Fit oil extraction pump. Use new sealing ring and new micro-encapsulated hexagon socket head screws. Tightening
torque: 10 Nm (7.5 ft. lbs.).
21. Fit camshaft closure cap dry.
22. Fit closure cap on tensioning element (VarioCam). Tightening torque: 10 Nm (7.5 ft. lbs.).
Removing valve tappets of cylinder bank 4 - 6
1. Remove fixing pin. Turn crankshaft 360° clockwise until the bore 1 OT (top dead center) in the pulley is aligned with the fixing bore on the
crankcase. Position or fix with fixing pin (short) of special tool 9595.
2. Check camshaft adjustment at cylinder bank 4 - 6: The groove in the camshaft must face inward toward the crankcase.
3. Unscrew chain tensioner of cylinder bank 4 - 6.
