Boxster S (987) F6-3.2L (2005)
/f6-3.2l/Page-339001.png)
Variable Valve Timing Solenoid: Procedures
Removing hydraulic valve for camshaft timing
ATTENTION: Risk of oil contamination and blocked oil bores
^
Faulty engine parts, engine damage
^
Absolute cleanliness is essential when working on hydraulic valves.
1. Disconnect cable plug on hydraulic valve -1 - by pressing the clip and pulling off the cable plug.
2. Unscrew two M6 x 20 inner Torx screws -2- at the valve holder and remove the holder along with the screws.
Note:
^
Handle the hydraulic valve with care, do not turn It at the valve t1p or at the safety contact.
^
A seal against leaks cannot be ensured if there is damage in the area of the retainer plate, therefore handle the pliers indicated with care.
3. Carefully pull the hydraulic valve out of the cylinder head using special tool relay puller 9235. Before using the puller, mask the valve body in
fabric tape in order to prevent slippage or damage.
