Boxster S (987) F6-3.2L (2005)
Toothed segment
Information: To avoid deforming the clutch pressure plate, always loosen fastening screws in at least 5 steps and in diametrically opposite sequence.
2. Detach pressure plate.
3. Remove pressure plate and drive plate.
Installing clutch
Installing clutch
Information:
^
Clean the friction surfaces of the flywheel and pressure plate prior to installation, e.g. with brake cleaner.
^
Surfaces of friction linings must be free from contamination, especially oil and grease.
1. Centering mandrel 3176 with drive plate must be inserted into the guide bearing (needle sleeve).
Information: To avoid deforming the clutch pressure plate, tighten fastening screws in at least 5 steps and in diametrically opposite sequence.
Always replace fastening screws.
2. Fit pressure plate.
3. Remove centering mandrel.
4. Remove toothed segment 9538/1.
Subsequent work
Subsequent work
1. Install transmission.