Boxster S (987) F6-3.4L (2008)
INFORMATION: The number of plugs can vary, depending on the vehicle equipment.
1. Release and pull off connectors -D and E- on the damaged antenna lead on the affected components. The illustration shows the connectors for the
PCM display and operator control unit as an example.
2. Cut off the connectors on the damaged antenna lead, then insulate it and tie it to the main wire harness.
3. Route the new antenna lead along the main wire harness, guide it through the existing cable ducts and tie it to the main wire harness using
tie-wraps.
4. Connect the connectors -D and E- for the new antenna lead to the affected components until the connectors are felt to engage. The illustration
shows the connectors for the PCM display and operator control unit as an example.
Subsequent work
Subsequent work for PCM/radio antenna lead up to antenna control unit
1. Install PCM display and operator control unit.