Boxster S (987) F6-3.4L (2008)
4. Undo both fastening screws -2- on the telephone control unit and pull the control unit from the cover.
Installing control unit for telephone
WARNING:
If the wiring at the telephone holder is not routed correctly, the wires can catch at the seat.
-
Danger of destroying/damaging wire harness for the telephone control unit.
-
The wire harness at the telephone holder must not be routed over the edge.
INFORMATION: The routing of the wire harness for the control unit must be checked before installing the seat.
The wire harness must not be routed over the cover, but should be laid along side the cover -A-.
1. Insert control unit into the cover and screw tight with the two fastening screws -2-. - Tightening torque: 2 Nm (1.5 ft. lbs.)
2. Push in electrical plug connections -C, B - until plugs are felt to engage.
3. Position plug -A- and close with the locking lever until the retainer clicks into place.