Boxster S (987) F6-3.4L (2008)
1. Position lower centre heat shield -3- together with rear support -8- and screw in with fastening screws -6-.
2. Screw in fastening screw -4- with washer -5-.
3. Position connecting angle -9- and screw in with fastening screws -7- to the fastening nuts -10-.
4. Position rear bumper -2- or (USA/Canada version) -2A- with mounted centre heat shield at the bottom -3-.
5. Tighten fastening screws -1-. Tightening torque: 85 Nm (63 ftlb.)
6. Check the functional dimensions of the rear bumper and the correct assembly of the heat shield and correct if necessary. Refer to Removing and
installing rear bumper
Installing support with heat shield at the sides