Boxster S (987) F6-3.4L (2008)
2. Screw in fastening screws -2- and tighten to the specified tightening torque. Final tightening: 1.5 ftlb..
3. Screw in fastening screws -3- and tighten to the specified tightening torque. Final tightening: 2 ftlb..
Installing front wheel housing liner - rear section
INFORMATION:
-
Push in wheel housing liner toward the outside up to contact in wing stop position.
-
Ensure that the right wheel housing liner is guided through the opening on the wheel well.
1. Insert wheel housing liner -A-.
2. Screw on fastening nuts -1- and tighten to the specified tightening torque. Final tightening: 1 ftlb..
3. Screw in fastening screws -2- and tighten to the specified tightening torque. Final tightening: 1.5 ftlb..
Subsequent work
Fit front wheel. Refer to Removing and installing wheel.