Boxster S (987) F6-3.4L (2008)
Wind Screen: Procedures
Eliminating Noise Symptoms - Reworking The Windstop
General information
Symptoms
Buzzing/rattling noises from around the windstop.
Causes and remedial action
Buzzing/rattling noises from between the windstop middle section and side roll-over bar; bodywork showing through the paintwork in places on the
roll-over bar.
In the event of a complaint, a profile section and two buffers must be fitted on the windstop middle section to remedy the situation on vehicles
manufactured before the date of introduction May 2005.
Tools and materials
987.561.825.00 Profile section
PROFILE SECTION
999.911.011.50 Buffer
BUFFER
Loctite 406
Loctite 406
Preliminary work
1. Remove the windstop middle section. Refer to Removing and installing windstop
Reworking the windstop
1. Stick a profile section -1- to the side of the windstop middle section -2- in area measuring -X= 5 mm- using -Loctite 406-.
2. Stick buffers -1- into the groove on the bottom of the windstop middle section -2-.