Boxster S (987) F6-3.4L (2008)
The seal for the convertible-top tip on the roof frame is in two parts.
1. Remove protective film and fit additional seal -4- flush with the roof frame.
INFORMATION: Make sure the additional seal is clamped under the retaining strip.
2. Insert seal for convertible top tip -3- into roof frame at front corners, position retaining strip -2- on the side of the roof frame and tighten with the
fastening screws -1-. Tightening torque: 2.8 Nm (2.0 ftlb.)
INFORMATION: Seal for convertible-top tip must not protrude downwards in the corner area. Make sure it is positioned correctly.
3. Screw down seal for convertible-top tip at the front corners with fastening screws -3-. Tightening torque: 3.5 Nm (2.5ftlb.)
4. Press lower seal -1- into profile of retaining strip -2-.
Installing cover strip