porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

ABOUT US
Removing and Installing Rear Seal (Tension Bow)|Page 4829 > < Removing and Installing Rear Seal (Tension Bow)|Page 4827

Boxster S (987) F6-3.4L (2008)

Page 4
background image

INFORMATION:  Seal for convertible-top tip must not be trapped. There must be no gap between seal and covering, and the seal with the covering
must run evenly. If necessary, pull the seal up and out and tap it in again.

1. Position cover strip -2- on roof frame -3- and screw down with the fastening screws -1-. Tightening torque : 3.5 Nm (2.5 ftlb.)

Subsequent work

End service position. Refer to convertible top service position.

Removing and Installing Rear Seal (Tension Bow)|Page 4829 > < Removing and Installing Rear Seal (Tension Bow)|Page 4827