Boxster S (987) F6-3.4L (2008)
Water Pump: Service and Repair
WM 195019 Removing and installing coolant pump
Preliminary work for removing coolant pump
Preliminary work for removing coolant pump
1. Place protective covers on the vehicle to avoid damaging the body.
2. Remove drive belt.
3. Remove rear underbody cover.
4. Drain coolant.
Removing coolant pump
Removing coolant pump
Danger
Vehicle raised incorrectly.
^
Danger of fatal injury or material damage should the vehicle fall down.
-->
Raise the vehicle at the prescribed jacking points.
Warning
Hot pressurized coolant.
^
Danger of scalding and burning.
-->
Only work on the coolant system when the engine is "cool".
-->
Wear protective clothes, gloves and goggles.
Warning
Coolant is corrosive and hazardous to health.
^
Risk of skin and eye irritation.
-->
Wear protective gloves and goggles.
-->
If you come into contact with coolant, wash off immediately with plenty of warm water.
1. Open spring band clamps -1, 4- then loosen and pull off coolant hoses -2, 3-.
View of coolant hoses
2. Unscrew seven Torx screws, two M6 x 30 and five M6 x 25 -arrows-.