Boxster S (987) F6-3.4L (2008)
Preliminary work for bearing cover for intermediate shaft
Preliminary work for bearing cover for intermediate shaft
Information
^
Note the work instructions for disconnecting and reconnecting the battery.
1. Disconnect the battery.
2. Drain engine oil.
Tiptronic:
3. Remove automatic transmission.
4. Remove drive plate for converter.
Manual transmission:
5. Remove manual transmission.
6. Remove clutch.
7. Remove double-mass flywheel.
Removing bearing cover for intermediate shaft
Removing bearing cover for intermediate shaft - up to engine number 62.504094
Caution
Timing chain may jump over.
^
Risk of engine damage
-->
Following removal of the chain tensioner, the crankshaft must not be turned under any circumstances.
Caution
Risk of damage due to particles of dirt.
^
Danger of material damage due to blocked oil bores/oil ducts.
-->
Absolute cleanliness is essential when working on the engine.
-->
Lay removed engine parts on a clean base and make sure to cover them.
-->
Use the cover for dust protection when fitting the engine NR.165 on the engine assembly support.