Boxster S (987) F6-3.4L (2008)
/f6-3.4l/Page-226005.png)
4. Unscrew two M6 x 12 hexagon-head bolts on the coolant pipe mount (Tiptronic) at cylinder side 1 - 3.
5. Remove primary chain tensioner (hexagon socket a/f 32).
Primary chain tensioner
6. Remove chain tensioner, cylinder bank 1 - 3 (hexagon socket a/f 32).
Chain tensioner, cylinders 1 - 3
Information
^
To make it easier to remove the bearing cover, spray the sealing surface with anti-rust agent.
7. Unscrew M8 hexagon collar nut on the bearing cover of the intermediate shaft with special tool socket wrench 9110, while at the same time
countering at the slotted threaded pin on the intermediate shaft with a screwdriver.
Collar nut for bearing cover
8. Unscrew the three M6 x 20 hexagon-head bolts (coated) on the intermediate-shaft flange. Replace coated screws during installation and clean
threaded bores.
Information
^
Remove bearing cover using special tool puller 9673. If this is not available, lever the bearing cover out carefully with two screwdrivers so as not
