Boxster S (987) F6-3.4L (2008)
Puller on bearing cover: View from intermediate shaft
10. Pull the slide hammer on the puller a number of times against the stop nuts while countering the tool at the same time with the other hand.
Removing bearing cover
11. If the puller is not available, lever the bearing cover out carefully using two screwdrivers (or angle screwdrivers), for example. Move the bearing
cover frequently to the left and right to make the levering easier. Do not damage the sealing surfaces.
Levering out bearing cover
Installing bearing cover for intermediate shaft
Installing bearing cover for intermediate shaft
Information
^
Clean working area of bore for bearing cover and crankcase thoroughly using acetone or solvent naphtha.
Information
^
Replace bearing cover or sealing ring for bearing cover.
1. Before installing the new bearing cover, check the fitted bore (axial attachment surface, bore chamfers) on the crankcase for sharp edges and burrs.
They should be removed with an oilstone or a polishing cloth. Remove any existing residue and clean the bore with a clean cloth soaked in solvent