Boxster S (987) F6-3.4L (2008)
/f6-3.4l/Page-264002.png)
Holder for solenoid hydraulic valve for camshaft timing
Information
^
Handle the hydraulic valve with care; do not turn it at the valve tip or at the safety contact.
^
A seal against leaks cannot be ensured if there is damage in the area of the retainer plate, therefore handle the pliers indicated with care.
3. Carefully pull the hydraulic valve out of the cylinder head using special tool relay puller 9235. Before using the puller, mask the valve body in
fabric tape in order to prevent slippage or damage.
Pulling out hydraulic valve with relay puller
4. Remove retainer plate with integrated seal -1- from the valve.
Installation position of retainer plate for solenoid hydraulic valve for camshaft timing
Information
^
Handle the hydraulic valve with care; do not turn it at the valve tip or at the safety contact.
^
A seal against leaks cannot be ensured if there is damage in the area of the retainer plate, therefore handle the pliers indicated with care.
5. Check the valve body for damage in the sealing area of the retainer plates. If necessary, the valve must be replaced.
6. Pull the oil strainer -1- out of the cylinder head bore using a bar magnet. Clean using solvent naphtha, check for damage and soiling, and replace if
necessary. Pay attention to the installation position.
