Boxster S (987) F6-3.4L (2008)
Removing compressor/condenser line
INFORMATION:
-
Close off all lines and connections using suitable plugs during removal.
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
1. Unscrew fastening screw -1- on compressor, pull out line on compressor and remove it from support -7-.
2. Unscrew fastening nut -5- on cable holder, open cable holder and pull line out of rubber mounting -6-.
3. Unscrew fastening screw -3- on connection point and pull out line.
4. Remove line downwards from the engine area.
Installing compressor/condenser line
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.