Boxster S (987) F6-3.4L (2008)
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.
1. Carefully push the lines into the condensers and screw tight with the fastening screws. - Tightening torque: 14 Nm (10.5 ft. lbs.)
2. Attach line to both holders, close holders and secure with fastening screws.
3. Engage air guide on condenser -A- and screw down using the two fastening screws -1-. - Tightening torque: 4 Nm (3 ft. lbs.)
Subsequent work
Subsequent work for line condenser-condenser
Filling in refrigerant.
Install front apron.
Removing and Installing Compressor-Condenser Line At Front
Removing And Installing Compressor-condenser Line At Front
Technical values
Preliminary work
Preliminary work on compressor-condenser line
Remove front right wheel.
Remove front right wheel housing liner.