Boxster S (987) F6-3.4L (2008)
1. Clip line into the line holder at the top and engage it in the rubber mounting.
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.
2. Insert compressor-condenser line into the line to the compressor and fasten with the fastening screw -2-. - Tightening torque: 14 Nm (10.5 ft. lbs.)
3. Close and engage holder for rubber mounting.
4. Insert compressor-condensor line into the condenser and fasten it with the fastening screw -1-. - Tightening torque: 14 Nm (10.5 ft. lbs.)
Subsequent work
Subsequent work on compressor-condenser line
Fill in refrigerant.
Install front right wheel housing liner.
Install front right wheel.
Removing and Installing Compressor/Evaporator Line
Removing And Installing Compressor/Evaporator Line
Technical values
Preliminary work
Preliminary work for compressor/evaporator line
Draining refrigerant.
Remove air-conditioning compressor from engine.
Removing compressor/evaporator line
INFORMATION:
-
Close off all lines and connections using suitable plugs during removal.