Boxster S (987) F6-3.4L (2008)
1. Push line into the plenum panel via the wheel housing and press rubber sleeve into place. Ensure that rubber sleeve is fitted correctly.
INFORMATION: When loosening or tightening the M8 refrigerant lines on the condenser, always counter with a 21-mm open-ended wrench.
2. Clip line into the line holder at the top, insert line into the condenser and screw down with -2- fastening screw. - Tightening torque: 14 Nm (10.5
ft. lbs.)
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.
3. Push together line in plenum panel and screw on with the -1- fastening screws. - Tightening torque: - 20 Nm (15 ft. lbs.)
Subsequent work
Subsequent work for line condenser-fluid tank
Filling in refrigerant.
Install front left wheel housing liner.
Installing front wheel.