Boxster S (987) F6-3.4L (2008)
13. Clip in the plastic holders for the electric main wire harness to the dashboard bracket.
14. Secure dashboard bracket with the fastening screw -4-. - Tightening torque: 9.7 Nm (7.0 ft. lbs.)
15. Screw down holder of heater/air-conditioning unit with the fastening screw -3-. - Tightening torque: 3.5 Nm (2.5 ft. lbs.)
16. Slide the fastening bolts of the heater/air-conditioning unit through the firewall lid and tighten with the three fastening nuts -6-. - Tightening
torque: 9.7 Nm (7.0 ft. lbs.)
INFORMATION:
-
Do not remove the plugs until just before installing the expansion valve.
-
Check the condition of foam parts for damage; if in doubt replace.
17. Install expansion valve and tighten with the two fastening screws -2-, replace sealing rings for refrigerant lines and wet them with refrigerant. -
Tightening torque: 9 Nm (6.5 ft. lbs.)