Boxster S (987) F6-3.4L (2008)
1. Insert new bulb into the bulb holder.
2. Position the cover and clip into place.
Replacing Bulb For Reading Light
CAUTION:
Danger of damage to property if bulbs are used or handled incorrectly.
-
Risk of damage to bulbs and bulb housing.
-
Switch off ignition and remove ignition key.
-
To prevent short circuits, the load in question must be switched off while changing bulbs.
-
Only bulbs specified in the bulb table may be used.
-
Bulbs with a higher wattage may damage the bulb housing.
-
New bulbs must be clean and free of grease. Therefore, never touch the bulbs with your bare hands. Use a cloth or soft paper when changing bulbs.
-
In certain states, it is compulsory to carry spare light bulbs.
INFORMATION: Only use the relevant bulb specified in the bulb table IN - Bulb table and installation instructions - "Information" chapter.
1. Pull the interior light out of the trim panel carefully from the front.
2. Release plug on interior light -arrow a- and pull it off.
3. Loosen bulb holder with bayonet lock -direction of arrow- and remove it.
4. Take defective bulb out of the bulb holder.
5. Insert new bulb into the bulb holder.