Boxster S (987) F6-3.4L (2008)
/f6-3.4l/Page-659038.png)
14.1. Before inserting the seal, check for signs of damage, and replace if necessary.
14.2. Insert seal into the connector and press down as far as it will go. Check seal is seated properly.
15. Push on connector on triggering unit for airbag -10- until it engages securely and lock it.
Installing wire harness for airbag from the A-pillar connection point to the head airbag
WARNING: Danger of injury and material damage if airbag units are not handled correctly.
-
Always observe the safety regulations for handling airbag units
-
Remove ignition key. Disconnect battery. Route or isolate the ground strap so that all contact with a ground carrier (e.g. body, seat frame) is
avoided.
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.
1. Release and disconnect plug connection for main wire harness to door wire harness -3 and 4-.
2. Release and pull off connector on head airbag on the left -5- and right -6-.
3. Cut off the head airbag connector on the damaged wire harness, insulate it and secure it to the door wire harness with tie-wraps.
4. Remove rubber sleeve -A- and carefully pull it and the door wire harness out of the A-pillar.
