Boxster S (987) F6-3.4L (2008)
7. Cut through the rubber sleeve at the side of the TPM line -a- and remove the TPM line -arrow B-.
Installing wire harness for anti-lock brake system (ABS)
Installing front ABS wire harness
1. Place socket in installation position -arrow A- and screw on the fastening screw. - Tightening torque: 10 Nm (7.5 ft. lbs.)
2. Plug in the two connectors -arrow B-.
3. Fold back the cable retainer -arrow C- until it engages correctly at the connectors.
4. Press the ABS wire harness into the supports by pressing on the rubber sleeves -arrows A-.
5. Secure line for headlight levelling system to the ABS wire harness using fabric tape -B-.
6. Place ABS wire harness in installation position -arrows C- and close clip -arrows D-.
7. Push through ABS wire harness to plenum panel -arrow-.
INFORMATION:
-
Select a place for the joint where there is enough space to join all the lines present.
-
Do not cut the lines too short in case they have to be laid in a different position if there is insufficient space in the area of the joint.
-
The electric lines are located in the plenum panel and are thus exposed to the highest demands.
-
The greatest care must be used in the individual work steps for stripping insulation from, crimping, and shrinking/insulating the electric lines.
-
The procedure for stripping insulation from, crimping, and shrinking/insulating the electric lines must be complied with and observed. The
procedures are described in detail in the repair kit for harnesses NR.155-1.