Boxster S (987) F6-3.4L (2008)
11. Release connector for outside temperature sensor -13- and pull it off.
12. Release connectors on both horns -14 and 15- and pull them off.
13. Release and pull off connector on servo motor for front lid release -16-.
14. Release and pull off connector on control unit for garage door opener/HomeLink -17-.
15. Unclip front-end wire harness on right side at tie-wraps -22-.
16. Release and disconnect plug connection on microswitch for lower part of front lid lock -18-.
17. Release connector on servo motor for front lid -19- and -arrows a- pull it off.
18. Release plug connection for front-end wire harness to main wire harness, left -20- and disconnect.
19. Pull off holders -24-.
20. Remove the three grommets -21- and pull the wire harness through the openings in the body.
21. Remove wire harness for front-end.
Installing wire harness for front-end
INFORMATION:
-
The wire harness for front end spare parts scope means the scope for fully-equipped vehicles. Depending on the vehicle equipment, connectors not
required are tied to the wire harness for front end using tie-wraps.
-
When doing this, ensure the lines are routed correctly so that no line becomes trapped or damaged.
1
- Plug connection for front-end wire harness to main wire harness right
2
- Fuse box for fan
3
- Connector for front-end control unit
4
- Ground point, left and right
5
- Connector for headlight, left and right
6
- Plug connection between front-end wire harness and front apron wire harness
7
- Plug connection for coolant fan
8
- Connector for control unit for coolant control
9
- Connector for control unit for coolant control
10
- Cable guide for sensor line for airbag, front left and right
11
- Connector for sensor line for airbag, front left and right
12
- Connector for emergency release, front
13
- Connector for outside temperature sensor
14
- Connector for horn, high-pitch
15
- Connector for horn, low-pitch
16
- Connector for servo motor for front lid release
17
- Connector for control unit for garage door opener/HomeLink