Removing and Installing Front Belt Lock
8. Unscrew fastening screw -3-.
9. Pull off wire harness -1- and remove front belt lock -4-.
Installing front belt lock
DANGER: Loosen the safety-related threaded joint.
-
Danger of injury if belt lock is not screwed on correctly.
-
Always replace fastening screws for belt lock after customer service and reworking.
-
It is not permissible to make alterations to the microencapsulated screws (e.g. use lubricant, loosen bolts, and screw them down again).
1. Position belt lock -4- and secure using the fastening screw -3-. Tightening torque: 50 Nm (37 ftlb.)
INFORMATION: The electric lead must not be routed too tightly around the seat cushion.
2. Lay wire harness -1- and press into the metal clip -2- ( -arrow A- ).
3. Press the three individual connectors -3- into the connector socket -1- until they engage firmly.
4. Secure new tie-wraps -2- on connector socket -1-.